Clemmons grew fast in the 1990s and 2000s, so most homes have newer plumbing, but older houses and some subdivisions from the polybutylene era do reach the point where replacing the supply lines beats patching them. A repipe installs new PEX or copper to every fixture or to the failing part of the house. Call the number on this page to be connected with a local plumber in Clemmons.
Clemmons went from about 6,000 residents in 1990 to roughly 21,000 by 2020, and its housing reflects that: Census survey data puts the median home at 1994, though about 29% were built before 1980. Those older houses and the subdivisions of the 1980s and early 1990s are where repiping questions come up. The village is on Winston-Salem/Forsyth County Utilities water, which is soft and chlorinated, with lead and copper not detected at the 90th percentile in the 2025 report, so the condition of the pipe itself is usually what decides things.
What to do now
- Find out what you have. Look at exposed pipe at the water heater, under sinks and in the crawl space or garage. Note any gray plastic marked PB.
- Write down the leak history. Where, when and what kind of fitting or pipe failed.
- Check pressure at several fixtures. Weak flow everywhere suggests a supply problem rather than one bad faucet.
- Know your shutoff. Make sure the main valve works so a new leak doesn't turn into water damage.
- Get an assessment. A plumber can tell you whether a repair, a partial repipe or a full one fits the house.
Symptoms and what they usually mean
| Symptom | Likely cause |
|---|---|
| Leaks at plastic fittings, gray pipe marked PB | Polybutylene reaching the end of its life |
| Pinholes on copper, often hot side first | Internal corrosion of aging copper |
| Rusty water from older taps | Galvanized steel corroding inside |
| Weak flow throughout an older house | Narrowed galvanized pipe or a failing line into the house |
| One drip in a newer home | A single bad fitting, usually a repair |
What affects the cost
- House size and how many fixtures need new lines
- Crawl space, basement or slab construction
- Whether you choose PEX or copper
- Replacing only a section versus the whole system
- Who handles drywall patching and paint
- Whether the line from the meter into the house is replaced at the same time
A partial repipe in a newer Clemmons house can be a fairly contained job, while replacing all the original pipe in a pre-1980 home is a bigger project with more openings to patch. Plumbing permits in Clemmons go through the joint Winston-Salem/Forsyth County Inspections Division, and the plumber typically applies for them electronically.
Repiping questions in Clemmons
Could a house built in the 1990s or later need repiping?
What causes pinhole leaks in copper pipe?
Does the utility's service line inventory say anything about the pipes inside my house?
Will the plumber have to open walls and ceilings?
More plumbing services in Clemmons
Repiping nearby
Sources
Last updated: